LUX Flight Controller【c-1069】

クリックで画像を表示
クリックで画像を表示
クリックで画像を表示

LUX Flight Controller

 


Hardware Features

USB Conflict resolution - Hardware inversion, SBUS or telemetry can be used on any of the 3 available hardware serial ports. USB will not interfere with peripherals.
High Speed SPI 8kHz Gyro
MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.
Dedicated Boot button for easy firmware flashing.
Reinforced solder pads for trouble-free direct soldering.
Extremely low profile design.
Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
Integrated FRSky RSSI Filter (RC filter).
Input voltage 6v to 24v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.

Software/Hardware Features

Cleanflight support (RACE target).
BLHeli flashing supported by hardware (Feature is currently under software development).
Raceflight ready
Betaflight ready

Specifications

STM32F303RCT6(256kB flash) 32-bit processor
MPU6500 Gyro/Accelerometer
High quality, gold plated PCB
Micro USB connector for programming
Dimensions: 36x36x6mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes 
Weight: 6g

Includes

1x Lux Flight Controller
2x 2x7 Straight Pin Headers


FC65412

この商品をチェックした人はこんな商品もチェックしています

ログイン・会員登録

My Cart

カートに商品は入っていません

新着商品

Contact Us

商品検索

paypal

QAV


HQ-Prop


Skyzone