FunFly Controller "NAZE32" [AIR32 Edition]

クリックで画像を表示
クリックで画像を表示
クリックで画像を表示

クリックで画像を表示
FunFly Controller "NAZE32" [AIR32 Edition]

インバータケーブルを必要とせずにS-BUSを直接サポート!


This is a mini version of NAZE32 Acro. This is a design cooperation with MultiWiiCopter Australia, based on the Paris Air Hero enclosure design. For more information and setup for this board, see MultiWiiCopter Paris Air Hero32 pages. A polycarbonate case is available for purchase from MultiWiiCopter.
PCB 37mm x 21mm5 gramSTM32F103CBT6 32-bit Cortex M3 processorMPU6500 Accelerometer/GyroBMP280 BarometerFlex port for UART/I2C - support bluetooth or serial telemetrySupports 6channel PWM or 8+ channel PPM RC InputDirectly supports S-BUS without need for inverter cable (connect S-BUS signal pin to RC channel 4)Supports Spektrum satellite on Flex port6 motor outputs for Tri/Quad/Hex or Quad + GimbalCan be powered by up to 16V directly (however note high voltage is passed through to receiver, so receiver must also be capable of 16V) input, unless using Spektrum satellite then it's OK.Micro USB for setup with Baseflight Configurator.Battery voltage monitoring (needs soldering)Buzzer/high power LED output (needs soldering)
A manual for this might be available at some point, however it runs standard baseflight firmware, so all the same features of AcroNaze32 are supported. To mount the board with USB port facing "forward", do "set align_board_yaw=180" from  CLI.

Included in package
1x Air32 PCB with headers soldered1x RC Breakout cable for 6 channels

この商品をチェックした人はこんな商品もチェックしています

ログイン・会員登録

My Cart

カートに商品は入っていません

商品検索

お問い合わせフォーム

paypal

QAV


HQ-Prop


Skyzone