Lumenier Razor Pro F3 BLHeli_32 45A 2-6s ESC 4個セット


Lumenier Razor Pro F3 BLHeli_32 45A 2-6s ESC4個セット

Benefits of BLHeli_32 Firmware on 32-bit ESC
32bit processors run faster than 8bit, at which we can expect better performance from the new 32bit ESC’s. Faster input signals with lower latency and higher update rate would be possible, such as Dshot1200 or even faster protocols! (Read about DSHOT) (Read about DSHOT1200)

The 32-bit platform also allows more functionality and features that simply wasn't possible on 8bit ESC's, such as

Programmable PWM frequency
Auto-timing for higher efficiency and realiability
Voltage/Current limiting
Adjustable “Brake on Stop” force
Improve direction change in Bidirectional mode
ESC Telemetry
RGB LED control
Configuring from FC using DShot commands
Note: Not all of these features have been implemented yet, some are still in development.

New F3 MCU running at 108MHz, (older ESCs use F0 at 48MHz)
Latest Gen. firmware using BLHeli_32 (Razor_32 target)
Supports DSHOT 1200, Proshot, Oneshot125 (125-250us), Oneshot42(41.7-83.3us) and Multishot (5-25us). Auto-detection.
Ultra-Lightweight, and compact size (12x28mm)
Adaptive timing, compatible with a wide range of motors and Kv
Sychronous rectification technology adds efficiency, damped light
Powerful regenerative braking / active braking.
2-6s LiPo battery compatible
Onboard RGB LED for customizable color
DSHOT 1200 compatible out of the box!
Difference between Lumenier Razor Pro, and standard Razor ESCs

Pro version features a higher quality, lower resistance current sensor.
Pro uses new generation Mosfets which have better heat dissipation allowing for higher current.

Input: 2-6s LiPoly
Constant: 45 Amps
Burst: 60 Amps
BEC: No BEC, OPTO only
Dimensions: 12x28x5mm
Signal wire: 15cm
Weight: 3g (without motor wires)
Solder pads: Lipo +-, PWM, TLM, LED, Motor Outputs. (Pads on top and bottom of the ESC)


4x Lumenier Razor Pro F3 BLHeli_32 45A 2-6s ESC
1x 35V 220uF LOW ESR Capacitor
1x Set of power and signal wires 
1x Clear heatshrink (note, use of heatshrink will reduce cooling)





My Cart