Lumenier Mini Razor Pro 4in1 20x20 F3 BLHeli_32 45A 2-6s ESC



Lumenier Mini Razor Pro 4in1 20x20 F3 BLHeli_32 45A 2-6s ESC

Benefits of BLHeli_32 Firmware on 32-bit ESC
32bit processors run faster than 8bit, at which we can expect better performance from the new 32bit ESC’s. Faster input signals with lower latency and higher update rate would be possible, such as Dshot1200 or even faster protocols! (Read about DSHOT) (Read about DSHOT1200)

The 32-bit platform also allows more functionality and features that simply wasn't possible on 8bit ESC's, such as

Programmable PWM frequency
Auto-timing for higher efficiency and reliability
Voltage/Current limiting
Adjustable “Brake on Stop” force
Improve direction change in Bidirectional mode
ESC Telemetry
RGB LED control
Configuring from FC using DShot commands
Note: Not all of these features have been implemented yet, some are still in development.

New F3 MCU running at 108MHz, (older ESCs use F0 at 48MHz)
Latest Gen. firmware using BLHeli_32 (Razor_32 target)
Supports DSHOT 1200, Proshot, Oneshot125 (125-250us), Oneshot42(41.7-83.3us) and Multishot (5-25us). Auto-detection.
Modular Power System for even further customization (modules sold separately)
Oversized motor pads for easy installation and maintenance
Adaptive timing, compatible with a wide range of motors and Kv
Synchronous rectification technology adds efficiency, damped light
Powerful regenerative braking / active braking.
2-6s LiPo battery compatible
Customize your Mini Razor Pro even further with optional power modules.

Note: Modules sold separately.

Input: 2-6s LiPoly
Constant: 45 Amps
Burst: 60 Amps
Dimensions: 33x46x5mm
Mounting holes: 20x20 M3
Signal wire: 7cm
Weight: 12.5g
8pin connector pinout: VBAT, Ground, Current ADC, TLM, Motor 1, Motor 2, Motor 3, Motor 4


1x Lumenier Mini Razor 4in1 20x20 F3 BLHeli_32 45A 2-6s ESC
1x 8pin micro JST-SH 7cm connector for 4in1 ESC to FC connection
4x M3 Rubber o-rings
4x M3 Anti-vibration gummies