Specification:

Model: SE2205 (H Version Upgraded)
KV: 2700KV
Weight: Approx. 26.9g (net weight included long AWG cables)

you can lower the weight if you shorten the long AWG cables
AWG Cable: 15cm
Prop Shaft Diameter: 5mm (CW)
Stator Diameter: 22mm
Stator Length: 5mm
Shaft Diameter: 3mm
Configuration: 12N14P
Motor Dimensions: Φ26.8×15.3mm
ldle Current: 0.00A @ 10V
Internal Resistance: 0.00Ω
Suitable ESC: 25-35A (depends on the propeller and battery you use)
HobbyWing’s XRotor works pretty well with SE2205 motor so it is recommended especially the XRotor 30A is small in size as small as some 10A-12A ESC.
Since SimonK and BLHeli might shutter during high RPM on small props (eg. 5030). So if you plan to drive the motor hard, please consider to get XRotor 30 because XRotor was tested at high RPM without any sync issue.
Suitable Battery: 3-4S Li-Po (refer to thrust test table and videos)

Includes:

1 x RCX SE2205 2700KV FPV Racing Edition Motor
1 x Hex Locknuts M5 (Slip-Resistant) – CW
1 x Circle Plate
1 x Set of M3*5 Screw