This is a mini version of NAZE32 Acro. This is a design cooperation with MultiWiiCopter Australia, based on the Paris Air Hero enclosure design. For more information and setup for this board, see MultiWiiCopter Paris Air Hero32 pages. A polycarbonate case is available for purchase from MultiWiiCopter.

PCB 37mm x 21mm5 gramSTM32F103CBT6 32-bit Cortex M3 processorMPU6500 Accelerometer/GyroBMP280 BarometerFlex port for UART/I2C - support bluetooth or serial telemetrySupports 6channel PWM or 8+ channel PPM RC InputDirectly supports S-BUS without need for inverter cable (connect S-BUS signal pin to RC channel 4)Supports Spektrum satellite on Flex port6 motor outputs for Tri/Quad/Hex or Quad + GimbalCan be powered by up to 16V directly (however note high voltage is passed through to receiver, so receiver must also be capable of 16V) input, unless using Spektrum satellite then it's OK.Micro USB for setup with Baseflight Configurator.Battery voltage monitoring (needs soldering)Buzzer/high power LED output (needs soldering)

Included in package

1x Air32 PCB with headers soldered1x RC Breakout cable for 6 channels